1U工业电源

输出

Output

直流电压DC Voltage

12V

额定电流Rated Current

15A

电流范围Current Range

0～15A

额定功率Rated Power

180W

波纹与噪声最大（备注2）Ripple & Noise Max（Note2）

120mVp-p

电压调整范围Voltage Adj. Range

±10%

电压精度（备注3）Voltage Tolerance（Note 3）

±7%

线性调整率（备注4）Line Regulation（Note 4）

±0.5%

负载调整率（备注5）Load Regulation（Note 5）

±2.0%

启动、上升时间Setup、Rise Time

500ms，30ms/230VAC  1200ms，30ms/115VAC(满载时Full load)

保持时间（Typ.）Hold up time（Typ.）

60ms/230VAC     14ms/115VAC(满载时Full load)

输入

Input

电压范围Voltage Range

100～240VAC,125～370VDC

频率范围Frequency Range

50/60Hz

效率（Typ.）Efficiency（Typ.）

82%

交流电流（Typ.）Ac Current（Typ.）

9.09A/110VAC    4.5A/220VAC

浪涌电流（Typ.）Inrush Current（Typ.）

冷启动Cold Start：42A/240VAC

漏电流（Typ.）Leakage Current（Typ.）

﹤5mA/240VAC

保护

Protection

过载保护Over load protection

105%～170%

保护模式：打嗝模式，负载异常条件移除后可自动恢复

Protection   type：Hiccup mode，recovers   automatically after fault condition is removed

过压保护Over Voltage protection

115%～150%

保护模式：打嗝模式，过压异常条件移除后可自动恢复

Protection   type：Hiccup mode，recovers   automatically after fault condition is removed

过温保护Over-temperature protection

保护模式：晶体内部接点温度超过140℃，关闭输出，当温度恢复正常可自动恢复

Protected   Mode: crystal internal contact temperature exceeds 140 ℃, turn off the output, when the   temperature returns to normal automatic recovery

环境

Environment

工作温度Working Temp

-10℃～60℃(请参照“减额曲线” Refer to "derating   curve ")

工作湿度Working Humidity

20～90%RH,无冷凝non-condensing

储存温度、湿度Storage Temp、Humidity

-30℃～75℃    10～98%RH,无冷凝non-condensing

温度系数Temp. Coefficiency

±0.03%/℃（0～50℃）（+5V）

耐振荡Vibration

10～500Hz,5G 10分钟/周期，X、Y、Z轴各60分钟 10Min/1 cycle，period for 60min,each along X,Y,Z axes

安规和电磁兼容

（备注7）

Safety   & EMC

（Note 7）

安全规范备注6 Safety Standards Not6

GB4943，EN60950

耐压Withstand Voltage 

I/P-O/P:1.5KVAC , O/P-FG:1.5KVAC

绝缘阻抗Isolation Resistance 

I/P-O/P 2KVAC/1min,I/P-FG 2KVAC/1min, O/P-FG 1KVAC/1min

电磁兼容发射EMI Conduction Radiation

符合Compliance to :EN55022, EN61000-3-2,3,FCC part15,GB9254   class B,GB17625.1

电磁兼容抗扰度EMS Immunity

符合Compliance to :EN61000-4-2,3,4,5,6,8,11,A级轻工业标准light industry level, criteria A

其它

Others

MBTF

≥100000h.

尺寸Dimension/包装Packing

198*98*50mm(L*W*H) /0.18KG;24pcs/2.6Kg

备注

Note

1.如未特别说明，所有规格参数均在输入为230VAC、额定负载、25℃环境温度下进行测量。

All parameters NOT specially mentioned are   measured at 230VAC input, rated load and 25℃ of   ambient temperature.

2.波纹和噪声测量方法：使用一条12"双绞线，同时终端要并联0.1uF和47uF的电容，在20MHZ带宽下进行量测。

Ripple & noise are measured at 20MHz   of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf   &47uf parallel capacitor.

3.精度：包含设定误差，线性调整率和负载调整率。

Tolerance: includes set up tolerance, line   regulation and load regulation.

4.线性调整率测量方法：在额定负载下，从低电压到高电压测试。

Line regulation is measured from low line   to high line at rated load.

5.负载调整率测量方法：从0%到100%额定负载。

Load regulation measurement: from 0% to   rated load of 100%

6.按照GB4943.1的要求，电源仅适用于海拔2000米以下地区和非热带气候条件下安全使用。

In accordance with the requirements of   GB4943.1 power applies only to an altitude of 2000 meters in the following   areas and non-tropical climate conditions for safe use.

7.电源被视为系统内元件的一部分，需结合终端设备进行电磁兼容相关确认。

The power supply is considered part of the system   components, to be with terminal equipment related to electromagnetic   compatibility Relevant confirmation..